What Is Grind & Seal?
Diamond grinding plus a premium clear sealer system — the natural, industrial-modern concrete look, dust-proofed and defended.
The Honest Middle Ground
Grind & seal sits between bare concrete and a full coating system — and for a lot of spaces it's the sweet spot. We grind the slab clean and smooth, harden it from within, and seal it under clear protective coats. The concrete's natural face stays on display: the swirls, the aggregate peeking through, the story the slab already tells. What changes is everything underneath your experience of it — no more dusting, no more staining, no more drinking in every spill.
Our five-step system goes beyond the basic "grind it and roll some sealer" job. After grinding, we treat the slab with a lithium silicate densifier that penetrates and hardens the surface from within. Then a penetrating base sealer ties into the densified concrete, and the finish is a premium urethane/siloxane hybrid topcoat — a two-front defense that most sealed floors simply don't have.
Why Urethane/Siloxane?
The hybrid chemistry is the special sauce. The aliphatic urethane side builds a tough, UV-stable wear film on top — the part that handles foot traffic, tires, and equipment. The siloxane side penetrates into the concrete and repels water and UV from inside the surface. Protection from the outside in and the inside out — which is why this finish thrives in places ordinary sealers fail, including outdoors.
- UV stable — won't yellow or chalk under Georgia sun
- Breathable — lets slab moisture escape instead of blistering
- Waterproof & salt resistant — sheds water, resists freeze-and-coastal-air damage
- Sheen options — low-sheen matte to wet-look gloss
- 7–15 year service life — with simple recoats when it finally wears
Grind & Seal — Layer by Layer
